Lift trucks can be dangerous machines. If you don’t use them properly, they can kill and injure people.
Follow this advice to help you and those you work with stay safe. Operating
■ carry out a pre-shift check of the lift truck;
■ wear operator restraints, where fitted;
■ look all around before moving off;
■ look in the direction of travel;
■ travel at a speed suitable for the location and the load you are carrying;
■ travel with the forks lowered, but clear of the ground;
■ watch out for pedestrians;
■ watch out for obstructions;
■ avoid sudden stops and violent braking;
■ slow down at corners, doorways, and at every danger spot and sound the horn where necessary;
■ apply the parking brake when leaving the lift truck;
■ face the lift truck and use steps and handholds when getting in or out.
∴
∴
| Hazard Category | Hazards | Controls |
| Over Turning | 1. Caused by maneuvering, with load elevated, driving too fast, breaking suddenly, striking objects and/or operating on unsuitable floors/support surfaces. | 1. Forklift opertors shall be suitably trained in the safe working practices and proedures of forklift trucks. 2. All forklift operators shall be competent and capable to operate the forklift and maintain in the highest standards and procedures. 3. Forklift operators shall not speed |
| Overloading | 1. By exceeding the maximum lifting capacity of the forklift truck | 1. Forklift operators shall ensure that the specified lifting capablities of the vehicle are not exceeded under any circumstances. 2. The weight of the load to be obtained to ensure that the capability of the forklift in not exceeded |
| Collision | 1. With structural elements, pipes, stacks or with other vehicles | 1. Operators shall ensure that safe working practices/ prcedures are achered at all times and adequate work space is maintained 2. Operators shall ensure that the speed of the forklift is kept at suitable and safe limit 3. Storage racks, etc. shall be positioned and secured in such a way so that they cannot be knocked over easily |
| Floor Failure | 1. Caused because of uneven or unsound floor surfaces or exceeding the load capacity of the floor | 1. The working capaity of lfoors, other than at ground level, shall be checked bedore forklift trucks are permitted. 2. Plans shall be obtained of work sites to ensure that there are no underground services, etc. Whih may ause the floor surface to collapse under the weight of the forklift, i.e. drains, ellars, etc. |
| Loss of Load | 1. Can ocur if devices are not fitted to stop loads from slipping off the forks or loads are not adequately seured | 1. Forklift operators shall ensure that all loads carried are adequately fixed and/or secured with items such as rope or ratchet straps, etc. 2. Bankman shall be utilized (if necessary) to keep loads secure |
| Explosion and Fire | 1. Can be caused by electrical shorting, leaking fuel pipes, dust aumulation (Internal combustion) and from hydrogen generatioin during battery charging. 2. The truck itself can be a source of ignition if operated in flamable atmospheres | 1. Maintenane programs shall be in place for all vehicles and kept up to date 2. Operators shall check the vehicle every time it is used to ensure that it is in a safe working condition 3. Sources of flammability and/or ignition shall be ontrolled to an aceptable level 4. Batteries, etc. chall never be charged in their fabrication or work areas |
| Carrying Passengers | 1. Caused by unauthorized personnel riding on the forklift while in operation | 1. Passengers shall never be carried unless seats and other facilities are provided. 2. Drivers shall not speed under any circumstances. 3. Only trained personnel shall operate forklifts |
| Crush Injuries to other Personnel | 1. Can occur if personnel are working in the drivers blind spot or if they walk out in front of the forklift when it is in motion | 1. Forklists shall be fitted with reversing alarms to warn other personnel of their presence. 2. All personnel shall be aware of machinery in use and ensure that they look before moving from one place to another |
| Crush Injuries to Personnel Working on Forklift | 1. Can occur if personnel put part of the body in moving parts of forklift, or fall when working from a working plateform on the forks of the forklift | 1. No person shall work from the forks of a forklift truck unless an especially designed work plateform is fitted i.e. personnel basket |
지게차 안전수칙!!!
너무 쉽게 찾을 수 있고, 예전 기사시험 주관식 단골문제입니다.
그만큼 일반재해 및 중대재해가 많이 발생되는 작업입니다.
끔찍한 사고 동영상에 유튜브에서 쉽게 찾아볼 수 있어서 별도로 업로드 안하려구요.
도로교통사고 & 산업재해가 발생되는 위험한 작업임을 꼭 기억하세요.
길에서 마주친다면 먼저 양보하고 돌아서 돌아서 돌아서 피해다니셔야 합니다.
감사합니다.
∴
Download Link -> Guidelines for the Safe lift trucks
제주도 서쪽 비양도라는 섬이 있습니다. . 비양도는 제주시 한림읍 비양리 위치해 있으며, 하늘에서 날오온 섬이라는 의미를 지니고 있습니다. 비양도는 한림항에서 약 1.1km 떨어져 있으며, 섬의 모양은 원형에 가깝고 약 2000여명의 주민이 거주하고 있습니다. 비양도의 중앙에는 해발 114m 높이의 비양봉 본석구가 있고, 서쪽 해안에는 제주도에서 가장 큰 초대형 화산탄들이 분포하고 있습니다. . 섬의 북쪽 해안에는 호니토(homito)로 알려진 굴뚝모양의 바위들이 약 20여기 분포하고 있다. 호니토는 용암이 흐르다가 습지 등의 물을 만나 수증기와 용암이 뒤섞여 분수처럼 솟구쳐 나와 쌓여 만들어졌으며, 천연기념물 제439호로 지정되어 있습니다. . 섬의 동쪽에는 펄렁못 엄습지와 마을 신당이 위치해 있습니다. 최근까지 비양도는 약 1,000년 전에 분출한 섬으로 알려져 왔으나 용암의 나이를 분석한 결과 27,000년 전에 형성된 것으로 조사되었습니다. . …